<html> <head> <base href="https://bugzilla.gnome.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - Scale factor too large on wayland backend with tiled monitors" href="https://bugzilla.gnome.org/show_bug.cgi?id=777470#c10">Comment # 10</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - Scale factor too large on wayland backend with tiled monitors" href="https://bugzilla.gnome.org/show_bug.cgi?id=777470">bug 777470</a> from <a href="page.cgi?id=describeuser.html&login=dan.doel%40gmail.com" title="Dan Doel <dan.doel@gmail.com>"> Dan Doel</a> <pre>Actually, Jonas was correct. I have two identical 4K displays connected. Each takes one DisplayPort cable as input, and MST streams drive two panels in each. I reset one of the monitors to DisplayPort 1.1 mode, which renders it unable to expose the MST tiles, and thus it runs in the 3840x2160@30 mode. Hopefully that's good enough (otherwise I'll have to switch out video cards). I left the other in DP1.2 mode running at the 60Hz modes. You can see the command outputs in the "30Hz + 60Hz" files. Interestingly in this setup, everything is scaled properly on the 30Hz monitor, but when I drag (Gnome or weston) window to the 60Hz monitor, it suddenly becomes huge. It will stay huge until I get it back on the 30Hz monitor, and make it realize it is so (just dragging it there doesn't seem to be enough, but trying to make it snap to a side is). And yes, weston-terminal also displays this behavior.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are on the CC list for the bug.</li> </ul> </body> </html>