[PATCH weston v2] ivi-shell: use install paths in example config

[Emil Velikov]

On 27 June 2018 at 12:12, Emil Velikov <emil.l.velikov at gmail.com> wrote:
> On 27 June 2018 at 12:01, Michael Tretter <m.tretter at pengutronix.de> wrote:
>> Hi,
>>
>> On Fri, 25 May 2018 08:46:16 +0200, Michael Tretter wrote:
>>> On Thu, 24 May 2018 17:08:47 +0200, Emre Ucan wrote:
>>> > The example weston.ini file uses source and build
>>> > directory paths. Therefore, it is only useful when
>>> > used on the same system that is used to build Weston.
>>> >
>>> > We can use install paths instead of build/source paths
>>> > to fix this problem.
>>> >
>>> > v2 changes:
>>> > - use $(westondatadir) instead of $(datadir)
>>> >
>>> > Reported-by: Michael Tretter <m.tretter at pengutronix.de>
>>> > Signed-off-by: Emre Ucan <eucan at de.adit-jv.com>
>>>
>>> Reviewed-by: Michael Tretter <m.tretter at pengutronix.de>
>>
>> Some variables that this patch touches have already been removed, but I
>> think it would still make change to rename 'abs_top_builddir' and
>> 'abs_top_srcdir'. Is there anything preventing this patch from being
>> applied?
>>
> Is this still required with the recently landed builddir changes by Dan/Pekka?
> I'll give it a look after lunch and can offer some feedback, after
> lunch. Gut feeling atm is that this breaks make check.
>
My gut feeling and coffee deprived brain were miles off.
Patch is spot on and is
Reviewed-by: Emil Velikov <emil.velikov at collabora.com>

An extra cool cleanup incoming ;-)
-Emil