[PATCH 2/2] drm/amd/display: Program OTG vtotal min/max selectors unconditionally

[Aurabindo Pillai]

[Why&How]

OTG_V_TOTAL_MIN/MAX_SEL bits are required to be programmed to 1 if
writes to OTG timing registers need to be honoured. This is usually
needed only when freesync is active. However, SubVP + DRR requires that
we're able to change timing even without freesync being active (but
supported). By unconditionally writing this bit to 1, we remove an
unnecessary dependency so that DMCUB can change OTG timing whenever it wants.

Signed-off-by: Aurabindo Pillai <aurabindo.pillai at amd.com>
---
 drivers/gpu/drm/amd/display/dc/dcn32/dcn32_optc.c | 11 ++---------
 1 file changed, 2 insertions(+), 9 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/dc/dcn32/dcn32_optc.c b/drivers/gpu/drm/amd/display/dc/dcn32/dcn32_optc.c
index 2ee798965bc2..6ef56fb32131 100644
--- a/drivers/gpu/drm/amd/display/dc/dcn32/dcn32_optc.c
+++ b/drivers/gpu/drm/amd/display/dc/dcn32/dcn32_optc.c
@@ -245,16 +245,9 @@ static void optc32_set_drr(
 		}
 
 		optc->funcs->set_vtotal_min_max(optc, params->vertical_total_min - 1, params->vertical_total_max - 1);
-		optc32_setup_manual_trigger(optc);
-	} else {
-		REG_UPDATE_4(OTG_V_TOTAL_CONTROL,
-				OTG_SET_V_TOTAL_MIN_MASK, 0,
-				OTG_V_TOTAL_MIN_SEL, 0,
-				OTG_V_TOTAL_MAX_SEL, 0,
-				OTG_FORCE_LOCK_ON_EVENT, 0);
-
-		optc->funcs->set_vtotal_min_max(optc, 0, 0);
 	}
+
+	optc32_setup_manual_trigger(optc);
 }
 
 static struct timing_generator_funcs dcn32_tg_funcs = {
-- 
2.39.2