[PATCH RFC 27/46] imx-drm: convert to componentised device support

Eric Nelson eric.nelson at boundarydevices.com
Mon Jan 6 18:31:53 PST 2014


Hi Russell,

On 01/06/2014 10:46 AM, Russell King - ARM Linux wrote:
> On Mon, Jan 06, 2014 at 06:41:28PM +0100, Philipp Zabel wrote:
>> Hi Eric,
>>
>> Am Freitag, den 03.01.2014, 12:14 -0700 schrieb Eric Nelson:
>>> This is an issue we've seen before. The SABRE Lite board has
>>> a voltage divider on the HPD pins and some monitors (esp. DVI
>>> monitors) either don't drive things high enough to assert HPD or
>>> bounce with connect/disconnect.
>>
>> Yes, I used a DVI monitor.
>>
>>> We've instrumented our 3.0.35 kernels to use the RX_SENSE bits
>>> instead.
>>
>> Reacting to RX_SENSE0 instead of HPD seems to work.
>
> However, it's non-compliant, because HPD can be lowered and raised by
> the sink when it changes its EDID data (eg, because you're connected
> through a switch and the routing has been changed.)
>
> So, reacting to RX_SENSE0 instead of HPD has to be a work-around enabled
> only for those boards which are broken in this regard.
>

I understand. We'll need to carry some patches for a while though,
since there are lots of these boards in the wild.

Regards,


Eric


More information about the dri-devel mailing list