[PATCH RFC 27/46] imx-drm: convert to componentised device support

[Philipp Zabel]

Am Montag, den 06.01.2014, 19:31 -0700 schrieb Eric Nelson:
> Hi Russell,
> 
> On 01/06/2014 10:46 AM, Russell King - ARM Linux wrote:
> > On Mon, Jan 06, 2014 at 06:41:28PM +0100, Philipp Zabel wrote:
> >> Hi Eric,
> >>
> >> Am Freitag, den 03.01.2014, 12:14 -0700 schrieb Eric Nelson:
> >>> This is an issue we've seen before. The SABRE Lite board has
> >>> a voltage divider on the HPD pins and some monitors (esp. DVI
> >>> monitors) either don't drive things high enough to assert HPD or
> >>> bounce with connect/disconnect.
> >>
> >> Yes, I used a DVI monitor.
> >>
> >>> We've instrumented our 3.0.35 kernels to use the RX_SENSE bits
> >>> instead.
> >>
> >> Reacting to RX_SENSE0 instead of HPD seems to work.
> >
> > However, it's non-compliant, because HPD can be lowered and raised by
> > the sink when it changes its EDID data (eg, because you're connected
> > through a switch and the routing has been changed.)
> >
> > So, reacting to RX_SENSE0 instead of HPD has to be a work-around enabled
> > only for those boards which are broken in this regard.
> >
> 
> I understand. We'll need to carry some patches for a while though,
> since there are lots of these boards in the wild.

Could you point me to your changes? Maybe this could be added to
mainline as a quirk enabled by a device tree property on sabrelite only.

regards
Philipp