[PATCH 3/8] drivers/mfd: Add lookup table for Panel Control as GPIO signal

Linus Walleij linus.walleij at linaro.org
Wed May 6 07:51:02 PDT 2015

On Wed, Apr 29, 2015 at 4:00 PM, Shobhit Kumar <shobhit.kumar at intel.com> wrote:

> On some Intel SoC platforms, the panel enable/disable signals are
> controlled by CRC PMIC. Add those control as a new GPIO in a lookup
> table for gpio-crystalcove chip during CRC driver load
> v2: Make the lookup table static (Thierry)
>     Remove the lookup table during driver remove (Thierry)
> CC: Samuel Ortiz <sameo at linux.intel.com>
> Cc: Linus Walleij <linus.walleij at linaro.org>
> Cc: Alexandre Courbot <gnurou at gmail.com>
> Cc: Thierry Reding <thierry.reding at gmail.com>
> Signed-off-by: Shobhit Kumar <shobhit.kumar at intel.com>

Acked-by: Linus Walleij <linus.walleij at linaro.org>

Linus Walleij

More information about the dri-devel mailing list