[PATCH] gpu: ipu-v3: Fix CSI selection for VDIC

Philipp Zabel p.zabel at pengutronix.de
Tue Jun 6 08:22:56 UTC 2017


On Sat, 2017-06-03 at 11:57 -0700, Steve Longerbeam wrote:
> From: Marek Vasut <marex at denx.de>
> 
> The description of the CSI_SEL bit in the i.MX6 reference manual is
> incorrect. It states "This bit defines which CSI is the input to the
> IC. This bit is effective only if IC_INPUT is bit cleared".
> 
> From experiment it was found this is in fact not correct. The CSI_SEL
> bit selects which CSI is input to _both_ the VDIC _and_ the IC. If the
> IC_INPUT bit is set so that the IC is receiving from the VDIC, the IC
> ignores the CSI_SEL bit, but CSI_SEL still selects which CSI the VDIC
> receives from in that case.
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> Signed-off-by: Steve Longerbeam <steve_longerbeam at mentor.com>
> ---
>  drivers/gpu/ipu-v3/ipu-common.c | 15 ++++++++-------
>  1 file changed, 8 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/gpu/ipu-v3/ipu-common.c b/drivers/gpu/ipu-v3/ipu-common.c
> index 16d5568..2fb5f43 100644
> --- a/drivers/gpu/ipu-v3/ipu-common.c
> +++ b/drivers/gpu/ipu-v3/ipu-common.c
> @@ -725,15 +725,16 @@ void ipu_set_ic_src_mux(struct ipu_soc *ipu, int csi_id, bool vdi)
>  	spin_lock_irqsave(&ipu->lock, flags);
>  
>  	val = ipu_cm_read(ipu, IPU_CONF);
> -	if (vdi) {
> +	if (vdi)
>  		val |= IPU_CONF_IC_INPUT;
> -	} else {
> +	else
>  		val &= ~IPU_CONF_IC_INPUT;
> -		if (csi_id == 1)
> -			val |= IPU_CONF_CSI_SEL;
> -		else
> -			val &= ~IPU_CONF_CSI_SEL;
> -	}
> +
> +	if (csi_id == 1)
> +		val |= IPU_CONF_CSI_SEL;
> +	else
> +		val &= ~IPU_CONF_CSI_SEL;
> +
>  	ipu_cm_write(ipu, val, IPU_CONF);
>  
>  	spin_unlock_irqrestore(&ipu->lock, flags);

Applied, thanks.

regards
Philipp



More information about the dri-devel mailing list