[PATCH 7/7] drm/bridge: tc358767: use DP connector if no panel set
Andrzej Hajda
a.hajda at samsung.com
Mon Nov 19 07:34:13 UTC 2018
On 29.10.2018 12:47, Tomi Valkeinen wrote:
> tc358767 driver sets the connector type always to eDP.
>
> This patch sets the type to DP if there is no panel defined, which
> implies that there's a DP connector on the board.
>
> Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>
> ---
> drivers/gpu/drm/bridge/tc358767.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/gpu/drm/bridge/tc358767.c b/drivers/gpu/drm/bridge/tc358767.c
> index be013bd7b30b..db93d927cb9a 100644
> --- a/drivers/gpu/drm/bridge/tc358767.c
> +++ b/drivers/gpu/drm/bridge/tc358767.c
> @@ -1207,7 +1207,8 @@ static int tc_bridge_attach(struct drm_bridge *bridge)
> /* Create eDP connector */
> drm_connector_helper_add(&tc->connector, &tc_connector_helper_funcs);
> ret = drm_connector_init(drm, &tc->connector, &tc_connector_funcs,
> - DRM_MODE_CONNECTOR_eDP);
> + tc->panel ? DRM_MODE_CONNECTOR_eDP :
> + DRM_MODE_CONNECTOR_DisplayPort);
> if (ret)
> return ret;
>
Reviewed-by: Andrzej Hajda <a.hajda at samsung.com>
--
Regards
Andrzej
More information about the dri-devel
mailing list