[PATCH] drm: kirin: Fix for hikey620 display offset problem

[John Stultz]

From: Da Lv <lvda3 at hisilicon.com>

The original HiKey (620) board has had a long running issue
where when using a 1080p montior, the display would occasionally
blink and come come back with a horizontal offset (usually also
shifting the colors, depending on the value of the offset%4).

After lots of analysis by HiSi developers, they found the issue
was due to when running at 1080p, it was possible to hit the
device memory bandwidth limits, which could cause the DSI signal
to get out of sync.

Unfortunately the DSI logic doesn't have the ability to
automatically recover from this situation, but we can get a an
LDI underflow interrupt when it happens.

To then correct the issue, when we get an LDI underflow irq, we
we can simply suspend and resume the display, which resets the
hardware.

Thus, this patch enables the ldi underflow interrupt, and
initializes a workqueue that is used to suspend/resume the
display to recover. Then when the irq occurs we clear it and
schedule the workqueue to reset display engine.

Cc: Xinliang Liu <z.liuxinliang at hisilicon.com>
Cc: Rongrong Zou <zourongrong at gmail.com>
Cc: Xinwei Kong <kong.kongxinwei at hisilicon.com>
Cc: Chen Feng <puck.chen at hisilicon.com>
Cc: David Airlie <airlied at linux.ie>
Cc: Daniel Vetter <daniel at ffwll.ch>
Cc: dri-devel <dri-devel at lists.freedesktop.org>
Signed-off-by: Da Lv <lvda3 at hisilicon.com>
Signed-off-by: Yidong Lin <linyidong at huawei.com>
[jstultz: Reworded the commit message, checkpatch cleanups]
Signed-off-by: John Stultz <john.stultz at linaro.org>
Change-Id: I792ce0b50a1c941d94d8cbec6b52c0f838d967bd
---
 drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h |  6 ++++++
 drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c | 23 +++++++++++++++++++++++
 2 files changed, 29 insertions(+)

diff --git a/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h b/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
index 4cf281b7..ced40c6 100644
--- a/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
+++ b/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
@@ -87,6 +87,7 @@
 #define VSIZE_OFST			20
 #define LDI_INT_EN			0x741C
 #define FRAME_END_INT_EN_OFST		1
+#define UNDERFLOW_INT_EN_OFST		2
 #define LDI_CTRL			0x7420
 #define BPP_OFST			3
 #define DATA_GATE_EN			BIT(2)
@@ -97,6 +98,11 @@
 #define LDI_HDMI_DSI_GT			0x7434
 
 /*
+ *BIT_LDI_UNFLOW
+ */
+#define BIT_LDI_UNFLOW         BIT(2)
+
+/*
  * ADE media bus service regs
  */
 #define ADE0_QOSGENERATOR_MODE		0x010C
diff --git a/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c b/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
index 73611a9..1d935ab 100644
--- a/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
+++ b/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
@@ -58,6 +58,7 @@ struct ade_hw_ctx {
 struct ade_crtc {
 	struct drm_crtc base;
 	struct ade_hw_ctx *ctx;
+	struct work_struct drm_device_wq;
 	bool enable;
 	u32 out_format;
 };
@@ -176,6 +177,7 @@ static void ade_init(struct ade_hw_ctx *ctx)
 	 */
 	ade_update_bits(base + ADE_CTRL, FRM_END_START_OFST,
 			FRM_END_START_MASK, REG_EFFECTIVE_IN_ADEEN_FRMEND);
+	ade_update_bits(base + LDI_INT_EN, UNDERFLOW_INT_EN_OFST, MASK(1), 1);
 }
 
 static bool ade_crtc_mode_fixup(struct drm_crtc *crtc,
@@ -345,6 +347,18 @@ static void ade_crtc_disable_vblank(struct drm_crtc *crtc)
 			MASK(1), 0);
 }
 
+static void drm_underflow_wq(struct work_struct *work)
+{
+	struct ade_crtc *acrtc = container_of(work, struct ade_crtc,
+					      drm_device_wq);
+	struct drm_device *drm_dev = (&acrtc->base)->dev;
+	void __iomem *base = acrtc->ctx->base;
+	struct drm_atomic_state *state;
+
+	state = drm_atomic_helper_suspend(drm_dev);
+	drm_atomic_helper_resume(drm_dev, state);
+}
+
 static irqreturn_t ade_irq_handler(int irq, void *data)
 {
 	struct ade_crtc *acrtc = data;
@@ -362,6 +376,12 @@ static irqreturn_t ade_irq_handler(int irq, void *data)
 				MASK(1), 1);
 		drm_crtc_handle_vblank(crtc);
 	}
+	if (status & BIT_LDI_UNFLOW) {
+		ade_update_bits(base + LDI_INT_CLR, UNDERFLOW_INT_EN_OFST,
+				MASK(1), 1);
+		DRM_ERROR("LDI underflow!");
+		schedule_work(&acrtc->drm_device_wq);
+	}
 
 	return IRQ_HANDLED;
 }
@@ -1038,6 +1058,9 @@ static int ade_drm_init(struct platform_device *pdev)
 	/* vblank irq init */
 	ret = devm_request_irq(dev->dev, ctx->irq, ade_irq_handler,
 			       IRQF_SHARED, dev->driver->name, acrtc);
+
+	INIT_WORK(&acrtc->drm_device_wq, drm_underflow_wq);
+
 	if (ret)
 		return ret;
 
-- 
2.7.4