[PATCH] drm: kirin: Fix for hikey620 display offset problem
xinliang
z.liuxinliang at hisilicon.com
Sat Apr 20 01:10:29 UTC 2019
On 2019/4/20 2:00, John Stultz wrote:
> From: Da Lv <lvda3 at hisilicon.com>
>
> The original HiKey (620) board has had a long running issue
> where when using a 1080p montior, the display would occasionally
> blink and come come back with a horizontal offset (usually also
> shifting the colors, depending on the value of the offset%4).
>
> After lots of analysis by HiSi developers, they found the issue
> was due to when running at 1080p, it was possible to hit the
> device memory bandwidth limits, which could cause the DSI signal
> to get out of sync.
>
> Unfortunately the DSI logic doesn't have the ability to
> automatically recover from this situation, but we can get a an
> LDI underflow interrupt when it happens.
>
> To then correct the issue, when we get an LDI underflow irq, we
> we can simply suspend and resume the display, which resets the
> hardware.
>
> Thus, this patch enables the ldi underflow interrupt, and
> initializes a workqueue that is used to suspend/resume the
> display to recover. Then when the irq occurs we clear it and
> schedule the workqueue to reset display engine.
>
> Cc: Xinliang Liu <z.liuxinliang at hisilicon.com>
> Cc: Rongrong Zou <zourongrong at gmail.com>
> Cc: Xinwei Kong <kong.kongxinwei at hisilicon.com>
> Cc: Chen Feng <puck.chen at hisilicon.com>
> Cc: David Airlie <airlied at linux.ie>
> Cc: Daniel Vetter <daniel at ffwll.ch>
> Cc: dri-devel <dri-devel at lists.freedesktop.org>
> Signed-off-by: Da Lv <lvda3 at hisilicon.com>
> Signed-off-by: Yidong Lin <linyidong at huawei.com>
> [jstultz: Reworded the commit message, checkpatch cleanups]
> Signed-off-by: John Stultz <john.stultz at linaro.org>
Thanks for the patch John,
Reviewed-by: Xinliang Liu <z.liuxinliang at hisilicon.com>
Xinliang
> Change-Id: I792ce0b50a1c941d94d8cbec6b52c0f838d967bd
> ---
> drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h | 6 ++++++
> drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c | 23 +++++++++++++++++++++++
> 2 files changed, 29 insertions(+)
>
> diff --git a/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h b/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
> index 4cf281b7..ced40c6 100644
> --- a/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
> +++ b/drivers/gpu/drm/hisilicon/kirin/kirin_ade_reg.h
> @@ -87,6 +87,7 @@
> #define VSIZE_OFST 20
> #define LDI_INT_EN 0x741C
> #define FRAME_END_INT_EN_OFST 1
> +#define UNDERFLOW_INT_EN_OFST 2
> #define LDI_CTRL 0x7420
> #define BPP_OFST 3
> #define DATA_GATE_EN BIT(2)
> @@ -97,6 +98,11 @@
> #define LDI_HDMI_DSI_GT 0x7434
>
> /*
> + *BIT_LDI_UNFLOW
> + */
> +#define BIT_LDI_UNFLOW BIT(2)
> +
> +/*
> * ADE media bus service regs
> */
> #define ADE0_QOSGENERATOR_MODE 0x010C
> diff --git a/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c b/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
> index 73611a9..1d935ab 100644
> --- a/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
> +++ b/drivers/gpu/drm/hisilicon/kirin/kirin_drm_ade.c
> @@ -58,6 +58,7 @@ struct ade_hw_ctx {
> struct ade_crtc {
> struct drm_crtc base;
> struct ade_hw_ctx *ctx;
> + struct work_struct drm_device_wq;
> bool enable;
> u32 out_format;
> };
> @@ -176,6 +177,7 @@ static void ade_init(struct ade_hw_ctx *ctx)
> */
> ade_update_bits(base + ADE_CTRL, FRM_END_START_OFST,
> FRM_END_START_MASK, REG_EFFECTIVE_IN_ADEEN_FRMEND);
> + ade_update_bits(base + LDI_INT_EN, UNDERFLOW_INT_EN_OFST, MASK(1), 1);
> }
>
> static bool ade_crtc_mode_fixup(struct drm_crtc *crtc,
> @@ -345,6 +347,18 @@ static void ade_crtc_disable_vblank(struct drm_crtc *crtc)
> MASK(1), 0);
> }
>
> +static void drm_underflow_wq(struct work_struct *work)
> +{
> + struct ade_crtc *acrtc = container_of(work, struct ade_crtc,
> + drm_device_wq);
> + struct drm_device *drm_dev = (&acrtc->base)->dev;
> + void __iomem *base = acrtc->ctx->base;
> + struct drm_atomic_state *state;
> +
> + state = drm_atomic_helper_suspend(drm_dev);
> + drm_atomic_helper_resume(drm_dev, state);
> +}
> +
> static irqreturn_t ade_irq_handler(int irq, void *data)
> {
> struct ade_crtc *acrtc = data;
> @@ -362,6 +376,12 @@ static irqreturn_t ade_irq_handler(int irq, void *data)
> MASK(1), 1);
> drm_crtc_handle_vblank(crtc);
> }
> + if (status & BIT_LDI_UNFLOW) {
> + ade_update_bits(base + LDI_INT_CLR, UNDERFLOW_INT_EN_OFST,
> + MASK(1), 1);
> + DRM_ERROR("LDI underflow!");
> + schedule_work(&acrtc->drm_device_wq);
> + }
>
> return IRQ_HANDLED;
> }
> @@ -1038,6 +1058,9 @@ static int ade_drm_init(struct platform_device *pdev)
> /* vblank irq init */
> ret = devm_request_irq(dev->dev, ctx->irq, ade_irq_handler,
> IRQF_SHARED, dev->driver->name, acrtc);
> +
> + INIT_WORK(&acrtc->drm_device_wq, drm_underflow_wq);
> +
> if (ret)
> return ret;
>
More information about the dri-devel
mailing list