[PATCH v1 32/36] dt-bindings: display: convert sharp, ls037v7dw01 to DT Schema

[Rob Herring]

On Sun, Mar 29, 2020 at 1:04 PM Sam Ravnborg <sam at ravnborg.org> wrote:
>
> Hi Rob.
>
> > > +
> > > +  mode-gpios:
> > > +    description: |
> > > +      GPIO ordered MO, LR, and UD as specified in LS037V7DW01.pdf
> >
> > 3 or...
> >
> > > +      change configuration between QVGA and VGA mode and the
> > > +      scan direction. As these pins can be also configured
> > > +      with external pulls, all the GPIOs are considered
> > > +      optional with holes in the array.
> >
> > minItems: 3
> > maxItems: 5
>
> This binding can specify up to three GPIOs like this:

So it should be:

minItems: 1
maxItems: 3

> > > +        mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH        /* gpio154, lcd MO */
> > > +                      &gpio1 2 GPIO_ACTIVE_HIGH         /* gpio2, lcd LR */
> > > +                      &gpio1 3 GPIO_ACTIVE_HIGH>;       /* gpio3, lcd UD */
>
> They are in the linux kernel driver accessed like this:
>
>     devm_gpiod_get_index(&pdev->dev, "mode", 2, GPIOD_OUT_LOW);
>
> The following is OK in the DT file:
>
>     mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH>;
>
>     mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH
>                   &gpio1 2 GPIO_ACTIVE_HIGH>;
>
>     mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH
>                   &gpio1 2 GPIO_ACTIVE_HIGH
>                   &gpio1 3 GPIO_ACTIVE_HIGH>;

With the above, the 2nd 2 should fail...

> But the following is not OK:
>     mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH>, <&gpio1 2 GPIO_ACTIVE_HIGH>;

And this should pass. We want phandle+arg type properties to be
bracketed like this.

If that's not working, then it's a bug in the tooling. Please confirm
and I'll investigate.

Rob