[PATCH v3 4/4] drm/bridge: ti-sn65dsi83: Add vcc supply regulator support
Alexander Stein
alexander.stein at ew.tq-group.com
Tue Oct 19 06:52:39 UTC 2021
VCC needs to be enabled before releasing the enable GPIO.
Reviewed-by: Sam Ravnborg <sam at ravnborg.org>
Signed-off-by: Alexander Stein <alexander.stein at ew.tq-group.com>
---
drivers/gpu/drm/bridge/ti-sn65dsi83.c | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)
diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi83.c b/drivers/gpu/drm/bridge/ti-sn65dsi83.c
index 9072342566f3..c55c45d5d29a 100644
--- a/drivers/gpu/drm/bridge/ti-sn65dsi83.c
+++ b/drivers/gpu/drm/bridge/ti-sn65dsi83.c
@@ -33,6 +33,7 @@
#include <linux/of_device.h>
#include <linux/of_graph.h>
#include <linux/regmap.h>
+#include <linux/regulator/consumer.h>
#include <drm/drm_atomic_helper.h>
#include <drm/drm_bridge.h>
@@ -143,6 +144,7 @@ struct sn65dsi83 {
struct mipi_dsi_device *dsi;
struct drm_bridge *panel_bridge;
struct gpio_desc *enable_gpio;
+ struct regulator *vcc;
int dsi_lanes;
bool lvds_dual_link;
bool lvds_dual_link_even_odd_swap;
@@ -292,6 +294,11 @@ static void sn65dsi83_atomic_pre_enable(struct drm_bridge *bridge,
struct drm_bridge_state *old_bridge_state)
{
struct sn65dsi83 *ctx = bridge_to_sn65dsi83(bridge);
+ int ret;
+
+ ret = regulator_enable(ctx->vcc);
+ if (ret)
+ dev_err(ctx->dev, "Failed to enable vcc: %i\n", ret);
/*
* Reset the chip, pull EN line low for t_reset=10ms,
@@ -536,9 +543,14 @@ static void sn65dsi83_atomic_post_disable(struct drm_bridge *bridge,
struct drm_bridge_state *old_bridge_state)
{
struct sn65dsi83 *ctx = bridge_to_sn65dsi83(bridge);
+ int ret;
/* Put the chip in reset, pull EN line low. */
gpiod_set_value(ctx->enable_gpio, 0);
+
+ ret = regulator_disable(ctx->vcc);
+ if (ret)
+ dev_err(ctx->dev, "Failed to disable vcc: %i\n", ret);
}
static enum drm_mode_status
@@ -647,6 +659,12 @@ static int sn65dsi83_parse_dt(struct sn65dsi83 *ctx, enum sn65dsi83_model model)
ctx->panel_bridge = panel_bridge;
+ ctx->vcc = devm_regulator_get(dev, "vcc");
+ if (IS_ERR(ctx->vcc))
+ return dev_err_probe(dev, PTR_ERR(ctx->vcc),
+ "Failed to get supply 'vcc': %pe\n",
+ ctx->vcc);
+
return 0;
}
--
2.25.1
More information about the dri-devel
mailing list