[PATCH 21/21] panel: startek-kd070fhfid015: add support of this display

Alexandre Mergnat amergnat at baylibre.com
Wed Mar 15 15:59:29 UTC 2023


Hi Neil,

Le jeu. 9 mars 2023 à 15:51, Neil Armstrong
<neil.armstrong at linaro.org> a écrit :
> > +
> > +#include <drm/drm_crtc.h>
>
> Is this include needed ?

Seems not, I remove it.

> > +     struct gpio_desc *enable_gpio;
> > +     struct gpio_desc *reset_gpio;
> > +     struct gpio_desc *dcdc_en_gpio;
>
> Isn't this "DCDC" a regulator ???

According to the panel datasheet, this is an input signal needed
passing through TFT connector (PIN30):
"Power IC supply enable, High active"

> > +     /* Interface setting, video mode */
> > +     ret = mipi_dsi_generic_write(dsi,
> > +                     (u8[]){DSI_REG_IS, 0x14, 0x08, 0x00, 0x22, 0x00}, 6);
> > +     if (ret < 0) {
> > +             dev_err(dev, "failed to set display interface setting: %d\n",
> > +                     ret);
> > +             return ret;
> > +     }
>
> Use mipi_dsi_generic_write_seq(dsi, DSI_REG_IS, 0x14, 0x08, 0x00, 0x22, 0x00); instead,
> it's simpler and doesn't need explicit return check.

"mipi_dsi_generic_write_seq" doesn't exist but I will add it below
"mipi_dsi_dcs_write_seq" in drm_mipi_dsi.h
I must keep the return check to jump out of "stk_panel_init" if
something goes wrong, but I can drop the error print.

> > +static int stk_panel_enable(struct drm_panel *panel)
> > +{
> > +     struct stk_panel *stk = to_stk_panel(panel);
> > +
> > +     if (stk->enabled)
> > +             return 0;
> > +
> > +     backlight_enable(stk->backlight);
> > +
> > +     stk->enabled = true;
> > +
> > +     return 0;
> > +}
>
> Is this really needed ? the backlight core will enable it automatically.

Ok, it's managed by drm_panel.c driver.
Then I can also remove stuff from stk_panel_disable.


Regards,
Alex


More information about the dri-devel mailing list