[PATCH V2 1/2] drm/bridge: adv7511: Allow IRQ to share GPIO pins

[Dmitry Baryshkov]

On Mon, Mar 04, 2024 at 06:48:57PM -0600, Adam Ford wrote:
> The IRQ registration currently assumes that the GPIO is dedicated
> to it, but that may not necessarily be the case. If the board has
> another device sharing the GPIO, it won't be registered and the
> hot-plug detect fails to function.
> 
> Currently, the handler reads two registers and blindly
> assumes one of them caused the interrupt and returns IRQ_HANDLED
> unless there is an error. In order to properly do this, the IRQ
> handler needs to check if it needs to handle the IRQ and return
> IRQ_NONE if there is nothing to handle.  With the check added
> and the return code properly indicating whether or not it there
> was an IRQ, the IRQF_SHARED can be set to share a GPIO IRQ.
> 
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> ---
> V2:  Add check to see if there is IRQ data to handle
> 

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>

-- 
With best wishes
Dmitry