[Freedreno] Prebuild fedora kernel for IFC6410

[Rob Clark]

On Fri, Aug 29, 2014 at 4:51 PM, XoD <xoddark at gmail.com> wrote:
> Hello,
>
> After some try, I have successfully boot my fedora with your upstream kernel
> image Rob (from kernel 3.16-rc3 I think so).
>
> With it, I don't have ethernet on the board, this is normal ?

wifi needs some firmware, but ethernet should just work..

> And, for information, I have a lot of time this message :
> [drm:mdp4_irq_error_handler] *ERROR* errors: 00000400

one of two of these during modeset is normal..  if you get a steady
stream of them, that is not normal.

BR,
-R

> But I have successfully get the /proc/config.gz, and I have to investigate
> of the diff bettween your and my kernel build config ... when i have some
> time.
>
> Thank for your help, I'll try to keep you updated when I have something new.
>
> PS: To test, I also replace the android in emmc with linaro gnome image, so
> I tested gnome environment on an arm signle board board :)
>
>
>
>
> 2014-08-27 14:08 GMT+02:00 XoD <xoddark at gmail.com>:
>
>> of course, say like that it has immediately more sense :)
>>
>>
>> 2014-08-27 14:03 GMT+02:00 Nicolas Dechesne <nicolas.dechesne at linaro.org>:
>>
>>>
>>> On Wed, Aug 27, 2014 at 1:28 PM, XoD <xoddark at gmail.com> wrote:
>>>>
>>>> I have look-at the kernel cmd line, with some small diff, but apparently
>>>> nothing significative.
>>>> And I tried to extract files from initrd.img but found nothing in the
>>>> /proc folder, it's the place to found the config.gz ?
>>>
>>>
>>> /proc is a virtual filesystem so there is no /proc folder content in the
>>> initrd or in any rootfs. you have to boot the kernel, and then at the prompt
>>> you can look at /proc content (on a running system).
>>
>>
>