[Intel-gfx] [PATCH v2 1/4] drm/i915: Don't populate pipe_src_{w, h} multiple times

[ville.syrjala at linux.intel.com]

From: Ville Syrjälä <ville.syrjala at linux.intel.com>

If we ever end up doing the retry loop due to bandwidth constraints, we
would rewrite pipe_src_{w,n} based on adjusted_mode timings. But by that
time the encoder may have already replaced the adjusted_mode with a
fixed panel mode, which would then corrupt pipe_src_{w,h}.

v2: Use requested_mode and slap on a big comment from Daniel

Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
---
 drivers/gpu/drm/i915/intel_display.c | 16 ++++++++++++----
 1 file changed, 12 insertions(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index a91f20a..4fa97a5 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -8472,6 +8472,18 @@ intel_modeset_pipe_config(struct drm_crtc *crtc,
 	if (plane_bpp < 0)
 		goto fail;
 
+	/*
+	 * Determine the real pipe dimensions. Note that stereo modes can
+	 * increase the actual pipe size due to the frame doubling and
+	 * insertion of additional space for blanks between the frame. This
+	 * is stored in the crtc timings. We use the requested mode to do this
+	 * computation to clearly distinguish it from the adjusted mode, which
+	 * can be changed by the connectors in the below retry loop.
+	 */
+	drm_mode_set_crtcinfo(&pipe_config->requested_mode, CRTC_STEREO_DOUBLE);
+	pipe_config->pipe_src_w = pipe_config->requested_mode.crtc_hdisplay;
+	pipe_config->pipe_src_h = pipe_config->requested_mode.crtc_vdisplay;
+
 encoder_retry:
 	/* Ensure the port clock defaults are reset when retrying. */
 	pipe_config->port_clock = 0;
@@ -8480,10 +8492,6 @@ encoder_retry:
 	/* Fill in default crtc timings, allow encoders to overwrite them. */
 	drm_mode_set_crtcinfo(&pipe_config->adjusted_mode, CRTC_STEREO_DOUBLE);
 
-	/* set_crtcinfo() may have adjusted hdisplay/vdisplay */
-	pipe_config->pipe_src_w = pipe_config->adjusted_mode.crtc_hdisplay;
-	pipe_config->pipe_src_h = pipe_config->adjusted_mode.crtc_vdisplay;
-
 	/* Pass our mode to the connectors and the CRTC to give them a chance to
 	 * adjust it according to limitations or connector properties, and also
 	 * a chance to reject the mode entirely.
-- 
1.8.1.5