[Intel-gfx] [PATCH i-g-t] tests/chamelium: Set output pipe after mode change to refresh output

[Lyude Paul]

On Wed, 2017-06-14 at 14:47 +0300, Paul Kocialkowski wrote:
> This adds a call to igt_output_set_pipe in orde to refresh output via
> igt_output_refresh and ensure that mode override can take effect.
> 
> Without this change, using a lower resolution during frame dumps
> series with mode changes (e.g. test_display_frame_dump) would not
> commit the mode change to the output and leave it with a framebuffer
> too small for the previously-commited resolution.
> 
> This would cause the test to fail. This allows it to pass.
> 
> Signed-off-by: Paul Kocialkowski <paul.kocialkowski at linux.intel.com>
Reviewed-by: Lyude Paul <lyude at redhat.com>

Thanks for the important fix! This must have gotten broken with some
igt rework someone did down the line while I was gone. Will push in a
moment :).

> ---
>  tests/chamelium.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/tests/chamelium.c b/tests/chamelium.c
> index 2e14ccb9..76b14e95 100644
> --- a/tests/chamelium.c
> +++ b/tests/chamelium.c
> @@ -322,6 +322,8 @@ enable_output(data_t *data,
>  	igt_plane_set_fb(primary, fb);
>  	igt_output_override_mode(output, mode);
>  
> +	igt_output_set_pipe(output, output->config.pipe);
> +
>  	/* Clear any color correction values that might be enabled
> */
>  	igt_pipe_set_degamma_lut(primary->pipe, NULL, 0);
>  	igt_pipe_set_gamma_lut(primary->pipe, NULL, 0);
-- 
Cheers,
	Lyude