[Intel-gfx] [PATCH i-g-t] tests/chamelium: Set output pipe after mode change to refresh output

[Paul Kocialkowski]

On Wed, 2017-06-14 at 18:16 -0400, Lyude Paul wrote:
> On Wed, 2017-06-14 at 14:47 +0300, Paul Kocialkowski wrote:
> > This adds a call to igt_output_set_pipe in orde to refresh output via
> > igt_output_refresh and ensure that mode override can take effect.
> > 
> > Without this change, using a lower resolution during frame dumps
> > series with mode changes (e.g. test_display_frame_dump) would not
> > commit the mode change to the output and leave it with a framebuffer
> > too small for the previously-commited resolution.
> > 
> > This would cause the test to fail. This allows it to pass.
> > 
> > Signed-off-by: Paul Kocialkowski <paul.kocialkowski at linux.intel.com>
> 
> Reviewed-by: Lyude Paul <lyude at redhat.com>
> 
> Thanks for the important fix! This must have gotten broken with some
> igt rework someone did down the line while I was gone. Will push in a
> moment :).

Thanks for the review!

> > ---
> >  tests/chamelium.c | 2 ++
> >  1 file changed, 2 insertions(+)
> > 
> > diff --git a/tests/chamelium.c b/tests/chamelium.c
> > index 2e14ccb9..76b14e95 100644
> > --- a/tests/chamelium.c
> > +++ b/tests/chamelium.c
> > @@ -322,6 +322,8 @@ enable_output(data_t *data,
> >  	igt_plane_set_fb(primary, fb);
> >  	igt_output_override_mode(output, mode);
> >  
> > +	igt_output_set_pipe(output, output->config.pipe);
> > +
> >  	/* Clear any color correction values that might be enabled
> > */
> >  	igt_pipe_set_degamma_lut(primary->pipe, NULL, 0);
> >  	igt_pipe_set_gamma_lut(primary->pipe, NULL, 0);
-- 
Paul Kocialkowski <paul.kocialkowski at linux.intel.com>
Intel Finland Oy - BIC 0357606-4 - Westendinkatu 7, 02160 Espoo