[Intel-gfx] [PATCH v3 1/2] drm/i915/skl+: Check for supported plane configuration in Interlace mode

[Mahesh Kumar]

In Gen9 platform Interlaced fetch mode doesn't support following plane
configuration:
 - Y/Yf tiling
 - 90/270 rotation
 - YUV420 hybrid planar source pixel formats.

This patch adds check to fail the flip if any of the above configuration
is requested.

Changes since V1:
 - handle checks in intel_plane_atomic_check_with_state (ville)
 - takeout plane scaler checks combile with pipe scaler in next patch
Changes since V2:
 - No need to check for NV12 as it need scaling, so it will be rejected
   by scaling check (ville)

Signed-off-by: Mahesh Kumar <mahesh1.kumar at intel.com>
---
 drivers/gpu/drm/i915/intel_atomic_plane.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/drivers/gpu/drm/i915/intel_atomic_plane.c b/drivers/gpu/drm/i915/intel_atomic_plane.c
index 4325cb0a04f5..ee76fab7bb6f 100644
--- a/drivers/gpu/drm/i915/intel_atomic_plane.c
+++ b/drivers/gpu/drm/i915/intel_atomic_plane.c
@@ -114,6 +114,8 @@ int intel_plane_atomic_check_with_state(struct intel_crtc_state *crtc_state,
 	struct drm_i915_private *dev_priv = to_i915(plane->dev);
 	struct drm_plane_state *state = &intel_state->base;
 	struct intel_plane *intel_plane = to_intel_plane(plane);
+	const struct drm_display_mode *adjusted_mode =
+		&crtc_state->base.adjusted_mode;
 	int ret;
 
 	/*
@@ -173,6 +175,19 @@ int intel_plane_atomic_check_with_state(struct intel_crtc_state *crtc_state,
 	if (ret)
 		return ret;
 
+	/*
+	 * Y-tiling is not supported in IF-ID Interlace mode in
+	 * GEN9 and above.
+	 */
+	if (state->fb && INTEL_GEN(dev_priv) >= 9 && crtc_state->base.enable &&
+	    adjusted_mode->flags & DRM_MODE_FLAG_INTERLACE) {
+		if (state->fb->modifier == I915_FORMAT_MOD_Y_TILED ||
+		    state->fb->modifier == I915_FORMAT_MOD_Yf_TILED) {
+			DRM_DEBUG_KMS("Y/Yf tiling not supported in IF-ID mode\n");
+			return -EINVAL;
+		}
+	}
+
 	/* FIXME pre-g4x don't work like this */
 	if (intel_state->base.visible)
 		crtc_state->active_planes |= BIT(intel_plane->id);
-- 
2.13.0