[Intel-gfx] [PATCH] Revert "drm/i915/bxt: Disable device ready before shutdown command"

[Mika Kahola]

The revert patch solved the issue

*ERROR* Video mode command 0x00000041 send failed.

on my setup with APL+MIPI/DSI single link combo.

Tested-by: Mika Kahola <mika.kahola at intel.com>


On Tue, 2017-09-05 at 15:14 +0530, Vidya Srinivas wrote:
> From: Uma Shankar <uma.shankar at intel.com>
> 
> This reverts commit bbdf0b2ff32aa75c7bd167569130e9391d2e6282.
> 
> Disable device ready before shutdown command was added previously to
> avoid a
> split screen issue seen on dual link DSI panels. As of now, dual link
> is not
> supported and will need some rework in the upstream code. For single
> link DSI
> panels, the change is not required. This will cause failure in
> sending SHUTDOWN
> packet during disable. Hence reverting the change. Will handle the
> change
> as part of dual link enabling in upstream.
> 
> Signed-off-by: Uma Shankar <uma.shankar at intel.com>
> Signed-off-by: Vidya Srinivas <vidya.srinivas at intel.com>
> ---
>  drivers/gpu/drm/i915/intel_dsi.c | 11 -----------
>  1 file changed, 11 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/intel_dsi.c
> b/drivers/gpu/drm/i915/intel_dsi.c
> index 2a0f5d3..fc25d7d 100644
> --- a/drivers/gpu/drm/i915/intel_dsi.c
> +++ b/drivers/gpu/drm/i915/intel_dsi.c
> @@ -892,8 +892,6 @@ static void intel_dsi_disable(struct
> intel_encoder *encoder,
>  			      const struct intel_crtc_state
> *old_crtc_state,
>  			      const struct drm_connector_state
> *old_conn_state)
>  {
> -	struct drm_device *dev = encoder->base.dev;
> -	struct drm_i915_private *dev_priv = dev->dev_private;
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder-
> >base);
>  	enum port port;
>  
> @@ -903,15 +901,6 @@ static void intel_dsi_disable(struct
> intel_encoder *encoder,
>  	intel_panel_disable_backlight(old_conn_state);
>  
>  	/*
> -	 * Disable Device ready before the port shutdown in order
> -	 * to avoid split screen
> -	 */
> -	if (IS_BROXTON(dev_priv)) {
> -		for_each_dsi_port(port, intel_dsi->ports)
> -			I915_WRITE(MIPI_DEVICE_READY(port), 0);
> -	}
> -
> -	/*
>  	 * According to the spec we should send SHUTDOWN before
>  	 * MIPI_SEQ_DISPLAY_OFF only for v3+ VBTs, but field testing
>  	 * has shown that the v3 sequence works for v2 VBTs too
-- 
Mika Kahola - Intel OTC