[Intel-gfx] [PATCH 1/2] drm/i915/cnl: Implement WaProgramMgsrForCorrectSliceSpecificMmioReads

Yunwei Zhang yunwei.zhang at intel.com
Wed Mar 14 23:22:38 UTC 2018


WaProgramMgsrForCorrectSliceSpecificMmioReads dictate that before any MMIO
read into Slice/Subslice specific registers, MCR packet control
register(0xFDC) needs to be programmed to point to any enabled
slice/subslice pair. Otherwise, incorrect value will be returned.

However, that means each subsequent MMIO read will be forwarded to a
specific slice/subslice combination as read is unicast. This is OK since
slice/subslice specific register values are consistent in almost all cases
across slice/subslice. There are rare occasions such as INSTDONE that this
value will be dependent on slice/subslice combo, in such cases, we need to
program 0xFDC and recover this after. This is already covered by
read_subslice_reg for INSTDONE.

Also, 0xFDC will lose its information after TDR/engine reset/power state
change.

Signed-off-by: Yunwei Zhang <yunwei.zhang at intel.com>
---
 drivers/gpu/drm/i915/intel_engine_cs.c | 43 ++++++++++++++++++++++++++++++++--
 1 file changed, 41 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_engine_cs.c b/drivers/gpu/drm/i915/intel_engine_cs.c
index a2b1e9e..bc8fed7 100644
--- a/drivers/gpu/drm/i915/intel_engine_cs.c
+++ b/drivers/gpu/drm/i915/intel_engine_cs.c
@@ -781,6 +781,29 @@ const char *i915_cache_level_str(struct drm_i915_private *i915, int type)
 	}
 }
 
+static u32 calculate_mcr(u32 mcr, struct drm_i915_private *dev_priv)
+{
+	const struct sseu_dev_info *sseu = &(INTEL_INFO(dev_priv)->sseu);
+	u32 slice = find_last_bit((unsigned long *)&(sseu->slice_mask),
+				   sizeof(sseu->slice_mask));
+	u32 subslice = find_last_bit((unsigned long *)&(sseu->subslice_mask[slice]),
+				      sizeof(sseu->subslice_mask[0]));
+
+	mcr &= ~(GEN8_MCR_SLICE_MASK | GEN8_MCR_SUBSLICE_MASK);
+	mcr |= GEN8_MCR_SLICE(slice) | GEN8_MCR_SUBSLICE(subslice);
+
+	return mcr;
+}
+
+static void wa_init_mcr(struct drm_i915_private *dev_priv)
+{
+	u32 mcr;
+
+	mcr = I915_READ(GEN8_MCR_SELECTOR);
+	mcr = calculate_mcr(mcr, dev_priv);
+	I915_WRITE(GEN8_MCR_SELECTOR, mcr);
+}
+
 static inline uint32_t
 read_subslice_reg(struct drm_i915_private *dev_priv, int slice,
 		  int subslice, i915_reg_t reg)
@@ -799,18 +822,31 @@ read_subslice_reg(struct drm_i915_private *dev_priv, int slice,
 	intel_uncore_forcewake_get__locked(dev_priv, fw_domains);
 
 	mcr = I915_READ_FW(GEN8_MCR_SELECTOR);
+
 	/*
 	 * The HW expects the slice and sublice selectors to be reset to 0
 	 * after reading out the registers.
 	 */
-	WARN_ON_ONCE(mcr & (GEN8_MCR_SLICE_MASK | GEN8_MCR_SUBSLICE_MASK));
+	if (INTEL_GEN(dev_priv) < 10)
+		WARN_ON_ONCE(mcr & (GEN8_MCR_SLICE_MASK |
+			     GEN8_MCR_SUBSLICE_MASK));
+
 	mcr &= ~(GEN8_MCR_SLICE_MASK | GEN8_MCR_SUBSLICE_MASK);
 	mcr |= GEN8_MCR_SLICE(slice) | GEN8_MCR_SUBSLICE(subslice);
 	I915_WRITE_FW(GEN8_MCR_SELECTOR, mcr);
 
 	ret = I915_READ_FW(reg);
 
-	mcr &= ~(GEN8_MCR_SLICE_MASK | GEN8_MCR_SUBSLICE_MASK);
+	/*
+	 * WaProgramMgsrForCorrectSliceSpecificMmioReads:cnl
+	 * expects mcr to be programed to a enabled slice/subslice pair
+	 * before any MMIO read into slice/subslice register
+	 */
+	if (INTEL_GEN(dev_priv) < 10)
+		mcr &= ~(GEN8_MCR_SLICE_MASK | GEN8_MCR_SUBSLICE_MASK);
+	else
+		mcr = calculate_mcr(mcr, dev_priv);
+
 	I915_WRITE_FW(GEN8_MCR_SELECTOR, mcr);
 
 	intel_uncore_forcewake_put__locked(dev_priv, fw_domains);
@@ -1278,6 +1314,9 @@ static int cnl_init_workarounds(struct intel_engine_cs *engine)
 	struct drm_i915_private *dev_priv = engine->i915;
 	int ret;
 
+	/* WaProgramMgsrForCorrectSliceSpecificMmioReads: cnl */
+	wa_init_mcr(dev_priv);
+
 	/* WaDisableI2mCycleOnWRPort:cnl (pre-prod) */
 	if (IS_CNL_REVID(dev_priv, CNL_REVID_B0, CNL_REVID_B0))
 		I915_WRITE(GAMT_CHKN_BIT_REG,
-- 
2.7.4



More information about the Intel-gfx mailing list