[Intel-gfx] [PATCH v6 20/20] drm/i915/icl: Set max return packet size for DSI panel

[Madhav Chauhan]

This patch programs maximum size of the payload transmitted
from peripheral back to the host processor using short packet
as a part of panel programming.

v2: Rebase

Signed-off-by: Madhav Chauhan <madhav.chauhan at intel.com>
---
 drivers/gpu/drm/i915/icl_dsi.c | 28 ++++++++++++++++++++++++++++
 1 file changed, 28 insertions(+)

diff --git a/drivers/gpu/drm/i915/icl_dsi.c b/drivers/gpu/drm/i915/icl_dsi.c
index ae8877a..a243349 100644
--- a/drivers/gpu/drm/i915/icl_dsi.c
+++ b/drivers/gpu/drm/i915/icl_dsi.c
@@ -25,6 +25,7 @@
  *   Jani Nikula <jani.nikula at intel.com>
  */
 
+#include <drm/drm_mipi_dsi.h>
 #include "intel_dsi.h"
 
 static enum transcoder dsi_port_to_transcoder(enum port port)
@@ -640,6 +641,30 @@ static void gen11_dsi_enable_port_and_phy(struct intel_encoder *encoder,
 	gen11_dsi_configure_transcoder(encoder, pipe_config);
 }
 
+static void gen11_dsi_powerup_panel(struct intel_encoder *encoder)
+{
+	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
+	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
+	struct mipi_dsi_device *dsi;
+	enum port port;
+	enum transcoder dsi_trans;
+	u32 tmp;
+	int ret;
+
+	/* set maximum return packet size */
+	for_each_dsi_port(port, intel_dsi->ports) {
+		dsi_trans = dsi_port_to_transcoder(port);
+		tmp = I915_READ(DSI_CMD_RXCTL(dsi_trans));
+		tmp &= NUMBER_RX_PLOAD_DW_MASK;
+		/* multiply "Number Rx Payload DW" by 4 to get max value */
+		tmp = tmp * 4;
+		dsi = intel_dsi->dsi_hosts[port]->device;
+		ret = mipi_dsi_set_maximum_return_packet_size(dsi, tmp);
+		if (ret < 0)
+			DRM_ERROR("error setting max return pkt size%d\n", tmp);
+	}
+}
+
 static void __attribute__((unused))
 gen11_dsi_pre_enable(struct intel_encoder *encoder,
 		     const struct intel_crtc_state *pipe_config,
@@ -654,6 +679,9 @@ gen11_dsi_pre_enable(struct intel_encoder *encoder,
 	/* step4: enable DSI port and DPHY */
 	gen11_dsi_enable_port_and_phy(encoder, pipe_config);
 
+	/* step5: program and powerup panel */
+	gen11_dsi_powerup_panel(encoder);
+
 	/* step6c: configure transcoder timings */
 	gen11_dsi_set_transcoder_timings(encoder, pipe_config);
 
-- 
2.7.4