[Intel-gfx] [PATCH v3 10/13] drm/i915/dsi: take compression into account in afe_clk()

Kulkarni, Vandita vandita.kulkarni at intel.com
Thu Dec 5 14:36:37 UTC 2019


> -----Original Message-----
> From: Jani Nikula <jani.nikula at intel.com>
> Sent: Tuesday, November 26, 2019 7:13 PM
> To: intel-gfx at lists.freedesktop.org
> Cc: Nikula, Jani <jani.nikula at intel.com>; Kulkarni, Vandita
> <vandita.kulkarni at intel.com>; Ville Syrjälä <ville.syrjala at linux.intel.com>
> Subject: [PATCH v3 10/13] drm/i915/dsi: take compression into account in
> afe_clk()
> 
> Pass crtc_state to afe_clk() to be able to take compression into account in
> the computation. Once we enable compression, that is.
> 
> Cc: Vandita Kulkarni <vandita.kulkarni at intel.com>
> Cc: Ville Syrjälä <ville.syrjala at linux.intel.com>
> Signed-off-by: Jani Nikula <jani.nikula at intel.com>

Looks good to me.
Reviewed-by: Vandita Kulkarni <vandita.kulkarni at intel.com>

Regards,
Vandita
> ---
>  drivers/gpu/drm/i915/display/icl_dsi.c | 40 +++++++++++++++-----------
>  1 file changed, 24 insertions(+), 16 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/display/icl_dsi.c
> b/drivers/gpu/drm/i915/display/icl_dsi.c
> index d576f29cef75..5149a28a874b 100644
> --- a/drivers/gpu/drm/i915/display/icl_dsi.c
> +++ b/drivers/gpu/drm/i915/display/icl_dsi.c
> @@ -302,17 +302,22 @@ static void configure_dual_link_mode(struct
> intel_encoder *encoder,  }
> 
>  /* aka DSI 8X clock */
> -static int afe_clk(struct intel_encoder *encoder)
> +static int afe_clk(struct intel_encoder *encoder,
> +		   const struct intel_crtc_state *crtc_state)
>  {
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
>  	int bpp;
> 
> -	bpp = mipi_dsi_pixel_format_to_bpp(intel_dsi->pixel_format);
> +	if (crtc_state->dsc.compression_enable)
> +		bpp = crtc_state->dsc.compressed_bpp;
> +	else
> +		bpp = mipi_dsi_pixel_format_to_bpp(intel_dsi-
> >pixel_format);
> 
>  	return DIV_ROUND_CLOSEST(intel_dsi->pclk * bpp, intel_dsi-
> >lane_count);  }
> 
> -static void gen11_dsi_program_esc_clk_div(struct intel_encoder *encoder)
> +static void gen11_dsi_program_esc_clk_div(struct intel_encoder *encoder,
> +					  const struct intel_crtc_state
> *crtc_state)
>  {
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base); @@ -
> 320,7 +325,7 @@ static void gen11_dsi_program_esc_clk_div(struct
> intel_encoder *encoder)
>  	int afe_clk_khz;
>  	u32 esc_clk_div_m;
> 
> -	afe_clk_khz = afe_clk(encoder);
> +	afe_clk_khz = afe_clk(encoder, crtc_state);
>  	esc_clk_div_m = DIV_ROUND_UP(afe_clk_khz, DSI_MAX_ESC_CLK);
> 
>  	for_each_dsi_port(port, intel_dsi->ports) { @@ -498,7 +503,9 @@
> static void gen11_dsi_enable_ddi_buffer(struct intel_encoder *encoder)
>  	}
>  }
> 
> -static void gen11_dsi_setup_dphy_timings(struct intel_encoder *encoder)
> +static void
> +gen11_dsi_setup_dphy_timings(struct intel_encoder *encoder,
> +			     const struct intel_crtc_state *crtc_state)
>  {
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base); @@ -
> 539,7 +546,7 @@ static void gen11_dsi_setup_dphy_timings(struct
> intel_encoder *encoder)
>  	 * leave all fields at HW default values.
>  	 */
>  	if (IS_GEN(dev_priv, 11)) {
> -		if (afe_clk(encoder) <= 800000) {
> +		if (afe_clk(encoder, crtc_state) <= 800000) {
>  			for_each_dsi_port(port, intel_dsi->ports) {
>  				tmp =
> I915_READ(DPHY_TA_TIMING_PARAM(port));
>  				tmp &= ~TA_SURE_MASK;
> @@ -649,7 +656,7 @@ gen11_dsi_configure_transcoder(struct intel_encoder
> *encoder,
>  			tmp |= EOTP_DISABLED;
> 
>  		/* enable link calibration if freq > 1.5Gbps */
> -		if (afe_clk(encoder) >= 1500 * 1000) {
> +		if (afe_clk(encoder, pipe_config) >= 1500 * 1000) {
>  			tmp &= ~LINK_CALIBRATION_MASK;
>  			tmp |= CALIBRATION_ENABLED_INITIAL_ONLY;
>  		}
> @@ -915,7 +922,8 @@ static void gen11_dsi_enable_transcoder(struct
> intel_encoder *encoder)
>  	}
>  }
> 
> -static void gen11_dsi_setup_timeouts(struct intel_encoder *encoder)
> +static void gen11_dsi_setup_timeouts(struct intel_encoder *encoder,
> +				     const struct intel_crtc_state *crtc_state)
>  {
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base); @@ -
> 930,7 +938,7 @@ static void gen11_dsi_setup_timeouts(struct intel_encoder
> *encoder)
>  	 * TIME_NS = (BYTE_CLK_COUNT * 8 * 10^6)/ Bitrate
>  	 * ESCAPE_CLK_COUNT  = TIME_NS/ESC_CLK_NS
>  	 */
> -	divisor = intel_dsi_tlpx_ns(intel_dsi) * afe_clk(encoder) * 1000;
> +	divisor = intel_dsi_tlpx_ns(intel_dsi) * afe_clk(encoder, crtc_state)
> +* 1000;
>  	mul = 8 * 1000000;
>  	hs_tx_timeout = DIV_ROUND_UP(intel_dsi->hs_tx_timeout * mul,
>  				     divisor);
> @@ -966,7 +974,7 @@ static void gen11_dsi_setup_timeouts(struct
> intel_encoder *encoder)
> 
>  static void
>  gen11_dsi_enable_port_and_phy(struct intel_encoder *encoder,
> -			      const struct intel_crtc_state *pipe_config)
> +			      const struct intel_crtc_state *crtc_state)
>  {
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> 
> @@ -983,13 +991,13 @@ gen11_dsi_enable_port_and_phy(struct
> intel_encoder *encoder,
>  	gen11_dsi_enable_ddi_buffer(encoder);
> 
>  	/* setup D-PHY timings */
> -	gen11_dsi_setup_dphy_timings(encoder);
> +	gen11_dsi_setup_dphy_timings(encoder, crtc_state);
> 
>  	/* step 4h: setup DSI protocol timeouts */
> -	gen11_dsi_setup_timeouts(encoder);
> +	gen11_dsi_setup_timeouts(encoder, crtc_state);
> 
>  	/* Step (4h, 4i, 4j, 4k): Configure transcoder */
> -	gen11_dsi_configure_transcoder(encoder, pipe_config);
> +	gen11_dsi_configure_transcoder(encoder, crtc_state);
> 
>  	/* Step 4l: Gate DDI clocks */
>  	if (IS_GEN(dev_priv, 11))
> @@ -1036,14 +1044,14 @@ static void gen11_dsi_powerup_panel(struct
> intel_encoder *encoder)  }
> 
>  static void gen11_dsi_pre_pll_enable(struct intel_encoder *encoder,
> -				     const struct intel_crtc_state *pipe_config,
> +				     const struct intel_crtc_state *crtc_state,
>  				     const struct drm_connector_state
> *conn_state)  {
>  	/* step2: enable IO power */
>  	gen11_dsi_enable_io_power(encoder);
> 
>  	/* step3: enable DSI PLL */
> -	gen11_dsi_program_esc_clk_div(encoder);
> +	gen11_dsi_program_esc_clk_div(encoder, crtc_state);
>  }
> 
>  static void gen11_dsi_pre_enable(struct intel_encoder *encoder, @@ -
> 1300,7 +1308,7 @@ static int gen11_dsi_compute_config(struct
> intel_encoder *encoder,
>  		pipe_config->pipe_bpp = 18;
> 
>  	pipe_config->clock_set = true;
> -	pipe_config->port_clock = afe_clk(encoder) / 5;
> +	pipe_config->port_clock = afe_clk(encoder, pipe_config) / 5;
> 
>  	return 0;
>  }
> --
> 2.20.1



More information about the Intel-gfx mailing list