[Intel-gfx] [PATCH v2] drm/i915: Add link rate and lane count to i915_display_info

[Khaled Almahallawy]

Link rate and lane count information are more easier and faster to check in i915_display_info
than checking kernel logs for people not familiar with i915 in the following scenarios:
* Debugging DP tunnel bandwidth usage in Thunderbolt driver.
* In USB4 certification, it is a requirement to know which link rate used by
  monitor to prove that DP tunnel handle up to HBR3
* In PHY Compliance, when the connector propes are not mounted correctly,
  some display lanes will not show up in the DP Oscilloscope and will fail CTS.
  Just give the tester an easy way to identify where the problem is.

v2(Ville): Uniform style for '=' and use 'port clock' instead of 'link rate'

Cc: Imre Deak <imre.deak at intel.com>
Cc: Ville Syrjälä <ville.syrjala at linux.intel.com>
CC: José Roberto de Souza <jose.souza at intel.com>
Signed-off-by: Khaled Almahallawy <khaled.almahallawy at intel.com>
---
 drivers/gpu/drm/i915/display/intel_display_debugfs.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/display/intel_display_debugfs.c b/drivers/gpu/drm/i915/display/intel_display_debugfs.c
index d62b18d5ecd8..cb088a0a26f3 100644
--- a/drivers/gpu/drm/i915/display/intel_display_debugfs.c
+++ b/drivers/gpu/drm/i915/display/intel_display_debugfs.c
@@ -990,9 +990,10 @@ static void intel_crtc_info(struct seq_file *m, struct intel_crtc *crtc)
 			   yesno(crtc_state->hw.active),
 			   DRM_MODE_ARG(&crtc_state->hw.adjusted_mode));
 
-		seq_printf(m, "\tpipe src size=%dx%d, dither=%s, bpp=%d\n",
+		seq_printf(m, "\tpipe src size=%dx%d, dither=%s, bpp=%d, port clock=%d, lane count=%d\n",
 			   crtc_state->pipe_src_w, crtc_state->pipe_src_h,
-			   yesno(crtc_state->dither), crtc_state->pipe_bpp);
+			   yesno(crtc_state->dither), crtc_state->pipe_bpp,
+			   crtc_state->port_clock, crtc_state->lane_count);
 
 		intel_scaler_info(m, crtc);
 	}
-- 
2.25.1