[Libdlo] help with mimo 710 on beagleboard

[Aaron Stowell]

I have my mimo 710 working on Ubuntu 8.10 using parallels.  However, I 
am trying to get it working on my beagleboard (arm) and I can't get past 
the green screen.  Anytime I send data to the monitor it goes gray or 
garbage... I did get it to turn blue by typing "clear" after using 
con2fbmap.

I've tried ubuntu 9.04, 8.04 (mojo), and angstrom

Here is my current log after plugin:

ubuntu at localhost:~$ sudo dmesg -c
[ 1465.778900] usb 1-2.1: new high speed USB device using ehci-omap and 
address 4
[ 1465.901245] usb 1-2.1: configuration #1 chosen from 1 choice
[ 1465.968200] generic-usb 0003:17E9:401A.0001: claimed by neither 
input, hiddev nor hidraw
[ 1466.307128] DisplayLink device attached
[ 1466.308837] ret control msg 0: 4 0501f0
[ 1466.400115] EDID XRES 0 YRES 0
[ 1466.400146] INIT VIDEO 0 800 480
[ 1466.400146] INIT VIDEO 1 1024 768
[ 1466.400177] INIT VIDEO 2 1280 1024
[ 1466.400665] ret control msg 1 (STD_CHANNEL): 16
[ 1466.400787] ret bulk 2: 156 156
[ 1466.400909] ret bulk 3: 0
[ 1466.400909] found valid mode...0
[ 1466.408142] screen base allocated !!!
[ 1466.417877] colormap allocated
[ 1466.487731] usbcore: registered new interface driver udlfb
[ 1466.487762] VMODES initialized

ubuntu at localhost:~$ cat /proc/fb
0 omapfb
1
2
3 nanovision MiMo

ubuntu at localhost:~$ con2fbmap 3 3

I have the green screen at this point.  However, after ctr-alt-F3 I get 
a black/grey screen.  (same as if I tried to start gdm).  Note: with 
con2fbmap I am able able to log in and make the screen change with 
commands like top and clear but still just garbage or solid colors.

Any ideas?

Thanks for all your work on this project.

-- Aaron