Reg AT commands to configure HUAWEI E392 dongle

[swarnalatha.subramaniya at wipro.com]

Hi,

I am trying to use E392 dongle in an residential gateway.

I am trying to configure the dongle with following AT commands,


at^ndisdup=1,1,"myapn"
OK
at^dhcp?
^DHCP:7796124d,f0ffffff,7196124d,7196124d,470d5c1,c60f4382,236800,236800

Converting the address to dotted quads to make them more readable:
77.18.150.119,255.255.255.240,77.18.150.113,77.18.150.113,193.213.112.4,130.67.15.198

ifconfig wwan0 77.18.146.77 netmask 255.255.255.252
ip route add default via 77.18.146.78

But i am not able to connect to the network with AT commands.

Please let me know if i am missing any AT commands ????????

Is QMI support mandatory to connect to the network.

regards,
Swarna

Please do not print this email unless it is absolutely necessary. 

The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments. 

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email. 

www.wipro.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freedesktop.org/archives/libqmi-devel/attachments/20130227/a2c2e981/attachment.html>