QMICLI IPV6 problem on MC7354

[Aleksander Morgado]

On Tue, Dec 16, 2014 at 6:36 PM, Bjørn Mork <bjorn at mork.no> wrote:
> Aleksander Morgado <aleksander at aleksander.es> writes:
>
>> I don't think so; the "WDS Start Network" given by qmicli
>> --wds-start-network gives just the APN to use, it doesn't give any
>> reference to the profile that was set with AT+CGDCONT. If you want to
>> use profiles, then qmicli needs to be modified to allow passing the
>> profile ID (e.g. a new --wds-start-network-id=[ID]").
>
> There is always a default profile used for parameters you don't give in
> the "WDS Start Network" command.  And because the PDP type is one of
> these, you *have* to create a default profile with the IPV4V6 type to
> create a successful dual stack connection.  It's just not possible to
> specify that PDP type any other way using QMI (AFAIK - it's been a while
> since I played with QMI).
>
> E.g., if I set my default profile like this (not recommended):
>
> at+cgdcont?
> +CGDCONT: 1,"IP","","0.0.0.0",0,0
>

Humm... how does the modem know that the default profile is that with ID 1?
There are QMI commands to change the default settings that QMI will
use in Start Network, I'm just not sure how that would apply if using
AT+CGDCONT.

-- 
Aleksander
https://aleksander.es