Netgear Aircard 341U in QMI mode, switching to 802.3

[Markus Gothe]

I discovered that the UML 295 needs sync, set format etc to come in a special sequence; if sync was run after set format things would break.

This is most likely the case here: one should use USBpcap in Windows to sniff the setup.

//M

Den 6 jun 2015 14:13 skrev Markus Gothe <nietzsche at lysator.liu.se>:
>
> Same issue with with the 770S actually… 
> However in MS Windows it does work for unknown reasons. :-/ 
>
> //M 
>
> On 06 Jun 2015, at 09:18 , Aleksander Morgado <aleksander at aleksander.es> wrote: 
>
> > On Sat, Jun 6, 2015 at 1:45 AM, Markus Gothe <nietzsche at lysator.liu.se> wrote: 
> >> The ugly duckling of Sprint? Yeah it behaves like the Sprint 770S I guess... Seems like Netgear management decided to default to raw-ip after taking over from Sierra Wireless, the same happened with last fw for 340U. I am still unsure if it needed WDA or if CTL did the job. 
> > 
> > It's even worst; WDA Set Data Format doesn't always work, I'm still 
> > trying to understand why. 
> > 
> > -- 
> > Aleksander 
> > https://aleksander.es 
> > _______________________________________________ 
> > libqmi-devel mailing list 
> > libqmi-devel at lists.freedesktop.org 
> > http://lists.freedesktop.org/mailman/listinfo/libqmi-devel 
>
> //Markus - The panama-hat hacker 
>
> _______________________________________________
> libqmi-devel mailing list
> libqmi-devel at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/libqmi-devel