Set technology preference to chosen type only.
aleksander at aleksander.es
Wed Feb 15 17:51:09 UTC 2017
On Wed, Feb 15, 2017 at 6:44 PM, Dan Williams <dcbw at redhat.com> wrote:
>> > > I just did the above, mostly because the card kept connecting on
>> > > UMTS
>> > > instead of LTE. (It would pick LTE maybe 50% of the time, sitting
>> > > at the
>> > > same location.)
>> > >
>> > > Now my card won't register. Ever heard of that?
>> > Is the LTE network coverage good enough where you're at? You can
>> > always set SSP back to "lte|umts".
>> I'm usually on LTE with the laptop in exactly the same place, with
>> near-100 signal strength, it just bumps to UMTS on occasion.
>> I tried the following:
>> $ sudo qmicli -d /dev/cdc-wdm0 -p
>> error: couldn't set operating mode: QMI protocol error (25):
>> What would the correct argument be?
> You might try "lte|umts|gsm" because sometimes the devices don't allow
> separating GSM and UTMS modes.
Also make sure you get the latest git master with the latest fix.
More information about the libqmi-devel