Firmware switch no longer supported?

[Paul Gildea]

Hi Daniele,

For previous Telit modems, the LM960 for example, each modem had several
carrier firmwares image that you can switch to with this command:

qmicli -p -d /dev/cdc-wdm<X> --gas-dms-set-active-firmware=<index>


 As there is now only one image present and listed with
--gas-dms-get-firmware-list, there is no valid option to switch to.

Thanks,
--
Paul

On Thu, 7 Sept 2023 at 12:05, Daniele Palmas <dnlplm at gmail.com> wrote:

> Hi Paul,
>
> Il giorno mer 6 set 2023 alle ore 22:02 Paul Gildea <gildeap at tcd.ie> ha
> scritto:
> >
> > Hi Daniele,
> >
> > So far I've tested with the FN990A40 and the new LN920 HW 1.1 revision.
> >
>
> Thanks, can you please let me know also which operation you are doing
> (e.g. the command line) and the model of the working module?
>
> I can try to investigate further.
>
> Regards,
> Daniele
>
> > Thanks,
> > Paul
> >
> > On Wed 6 Sept 2023, 20:43 Daniele Palmas, <dnlplm at gmail.com> wrote:
> >>
> >> Hi Paul,
> >>
> >> Il giorno mer 6 set 2023 alle ore 13:20 Paul Gildea <gildeap at tcd.ie>
> ha scritto:
> >> >
> >> > Hi,
> >> >
> >> > I notice that with new Telit modems that there is now only one
> firmware image installed, with an AT command (AT#FWSWITCH) to change MNO
> config and reboot, so changing operator doesn't work with LIBQMI, is that
> correct or is there an option I am not seeing?
> >>
> >> Which models are you referring to?
> >>
> >> Regards,
> >> Daniele
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/libqmi-devel/attachments/20230907/2cfbce52/attachment.htm>