[Mesa-dev] --libdir config option not working?

[Brian Paul]

On 08/23/2013 02:35 PM, Matt Turner wrote:
> On Fri, Aug 23, 2013 at 1:20 PM, Brian Paul <brianp at vmware.com> wrote:
>>
>> I don't normally do a 'make install' when I'm working, but I'm trying to do
>> that now on a 64-bit fedora 19 system.
>>
>> I want libGL.so*, etc to go into /usr/lib64/ so I configured like this:
>>
>> ./configure --prefix=/usr --libdir=/usr/lib64 --with-gallium-drivers=svga
>> --with-dri-drivers=swrast --enable-xa
>>
>> But 'make install' fails:
>>
>> [...]
>> gmake[6]: Entering directory
>> `/home/brian/projects/VM/mesa/src/mesa/drivers/dri/swrast'
>> gmake[6]: Nothing to be done for `install-exec-am'.
>>   /bin/mkdir -p '/usr/lib64/dri'
>>   /bin/sh ../../../../../libtool   --mode=install /bin/install -c
>> swrast_dri.la '/usr/lib64/dri'
>> libtool: install: error: cannot install `swrast_dri.la' to a directory not
>> ending in /usr/lib/dri
>> gmake[6]: *** [install-driLTLIBRARIES] Error 1
>> gmake[6]: Leaving directory
>> `/home/brian/projects/VM/mesa/src/mesa/drivers/dri/swrast'
>>
>> For some reason, libtool doesn't like /usr/lib64/dri
>>
>> Any ideas?
>
> I just configured my mesa directory with your configuration line, and
> ended up with a similar error upon make install.
>
> I think it was because my previously configured and built tree was
> built with some other prefix and libdir.
>
> After running git clean -dfx (although make clean would probably be
> fine) and configuring with your line, it worked

Thanks, Matt.  I repeated my experiment with a 'make clean' and that 
worked (though I swear I had tried that earlier).

-Brian