[Mesa-dev] [PATCH v3 1/8] i965: allocate a SGVS element when VertexID or InstanceID are read

[Antia Puentes]

From: Iago Toral Quiroga <itoral at igalia.com>

Although on gen8+ platforms we can in theory use 3DSTATE_VF_SGVS
to put these beyond the last vertex element it seems that we still
need to allocate the SVGS element, otherwise we have observed cases
where we end up reading garbage. Specifically, the CTS test mentioned
below was flaky with a fail rate of ~1% on some gen9+ platforms caused
by reading garbage for the gl_InstanceID value. The flakyness goes
away as soon as we start allocating the SVGS element.

v2:
  - Do this for gen8+, not just gen9+, and pull the boolean
    outside the #if block (Jason)

Fixes flaky test:
KHR-GL45.vertex_attrib_64bit.limits_test

Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=104335

Reviewed-by: Jason Ekstrand <jason at jlekstrand.net>
---
 src/mesa/drivers/dri/i965/genX_state_upload.c | 17 ++---------------
 1 file changed, 2 insertions(+), 15 deletions(-)

diff --git a/src/mesa/drivers/dri/i965/genX_state_upload.c b/src/mesa/drivers/dri/i965/genX_state_upload.c
index 50ac5bc59ff..d0a980f9730 100644
--- a/src/mesa/drivers/dri/i965/genX_state_upload.c
+++ b/src/mesa/drivers/dri/i965/genX_state_upload.c
@@ -486,26 +486,13 @@ genX(emit_vertices)(struct brw_context *brw)
    } else {
       brw_batch_emit(brw, GENX(3DSTATE_VF_SGVS), vfs);
    }
+#endif
 
-   /* Normally we don't need an element for the SGVS attribute because the
-    * 3DSTATE_VF_SGVS instruction lets you store the generated attribute in an
-    * element that is past the list in 3DSTATE_VERTEX_ELEMENTS. However if
-    * we're using draw parameters then we need an element for the those
-    * values.  Additionally if there is an edge flag element then the SGVS
-    * can't be inserted past that so we need a dummy element to ensure that
-    * the edge flag is the last one.
-    */
-   const bool needs_sgvs_element = (vs_prog_data->uses_basevertex ||
-                                    vs_prog_data->uses_baseinstance ||
-                                    ((vs_prog_data->uses_instanceid ||
-                                      vs_prog_data->uses_vertexid)
-                                     && uses_edge_flag));
-#else
    const bool needs_sgvs_element = (vs_prog_data->uses_basevertex ||
                                     vs_prog_data->uses_baseinstance ||
                                     vs_prog_data->uses_instanceid ||
                                     vs_prog_data->uses_vertexid);
-#endif
+
    unsigned nr_elements =
       brw->vb.nr_enabled + needs_sgvs_element + vs_prog_data->uses_drawid;
 
-- 
2.14.1