MM v1.4.6/Telit HE910-D SMS question

[Aleksander Morgado]

On Tue, Sep 1, 2015 at 2:12 PM, Highland, Glenn <Glenn.Highland at digi.com> wrote:
> I've performed the re-test you suggested below and attached the log showing the results.
> I did start MM in debug mode just so I could use it to enable the modem and then I
> ordered it to terminate gracefully, without having it connect to the cell network.
>
> I then ran AT+CNMI? over ttyACM3 and got the same erroneous result and then over ttyACM0
> which resulted in the good result, just as a check.
>
> As I understand it, the HE910-D is supposed to support command I/O over both USB
> endpoints - Telit issue?

Could you try with git master and not with 1.4.x?

The #PORTCFG based dynamic port identification logic, which applies to
the HE910, is only in git master.

-- 
Aleksander
https://aleksander.es