MM_BEARER_IP_FAMILY_ANY broken in MM 1.12.0?

[Aleksander Morgado]

Hey

>
> I’m using openwrt-master with latest mm 1.12.0 with EM7430 modem. As there were few discussions regarding using iptype as “any” in this forum so I tried it using below openwrt configuration
>
>
>
> config interface 'wwan'
>
>         option device '/sys/devices/platform/soc/soc:internal-regs/f10f8000.usb3/usb5/5-1'
>
>         option proto 'modemmanager'
>
>         option apn '4rf.com'
>
>         option iptype 'any'
>
>
>
> However, connection immediately gets disconnected after successful connect which results in indefinite cycle of
>
>
>
> enabling->enabled->registered->connecting->connected->disconnecting->registered->disabling->disabled->enabling->enabled-> and so on..
>
>
>
> Short log is below followed with detailed log for “bearer 6”. I had to stop modemmanager to stop this cycle
>
>
>
> Please note the problem does not happen if iptype is ‘ipv4’; this happens when iptype is set to ‘any’
>
>

Could you run MM in debug mode, and get logs when using "any" and when
using "ipv4" separately?
Please attach full logs as separate attachments, because browsing an
extremely long email body to find anything is very difficult :)

-- 
Aleksander
https://aleksander.es