MM_BEARER_IP_FAMILY_ANY broken in MM 1.12.0?

[Amol Lad]

Please find logs for mm in debug mode for iptype set to "ipv4" and "any" separately

Thanks
Amol



The information in this email communication (inclusive of attachments) is confidential to 4RF Limited and the intended recipient(s). If you are not the intended recipient(s), please note that any use, disclosure, distribution or copying of this information or any part thereof is strictly prohibited and that the author accepts no liability for the consequences of any action taken on the basis of the information provided. If you have received this email in error, please notify the sender immediately by return email and then delete all instances of this email from your system. 4RF Limited will not accept responsibility for any consequences associated with the use of this email (including, but not limited to, damages sustained as a result of any viruses and/or any action or lack of action taken in reliance on it).-----Original Message-----
From: Aleksander Morgado <aleksander at aleksander.es>
Sent: Friday, 15 November 2019 2:37 PM
To: Amol Lad <Amol.Lad at 4rf.com>
Cc: modemmanager-devel at lists.freedesktop.org
Subject: Re: MM_BEARER_IP_FAMILY_ANY broken in MM 1.12.0?

Hey

>
> I’m using openwrt-master with latest mm 1.12.0 with EM7430 modem. As
> there were few discussions regarding using iptype as “any” in this
> forum so I tried it using below openwrt configuration
>
>
>
> config interface 'wwan'
>
>         option device '/sys/devices/platform/soc/soc:internal-regs/f10f8000.usb3/usb5/5-1'
>
>         option proto 'modemmanager'
>
>         option apn '4rf.com'
>
>         option iptype 'any'
>
>
>
> However, connection immediately gets disconnected after successful
> connect which results in indefinite cycle of
>
>
>
> enabling->enabled->registered->connecting->connected->disconnecting->registered->disabling->disabled->enabling->enabled-> and so on..
>
>
>
> Short log is below followed with detailed log for “bearer 6”. I had to
> stop modemmanager to stop this cycle
>
>
>
> Please note the problem does not happen if iptype is ‘ipv4’; this happens when iptype is set to ‘any’
>
>

Could you run MM in debug mode, and get logs when using "any" and when using "ipv4" separately?
Please attach full logs as separate attachments, because browsing an extremely long email body to find anything is very difficult :)

--
Aleksander
https://aleksander.es
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: ip_type_any.txt
URL: <https://lists.freedesktop.org/archives/modemmanager-devel/attachments/20191115/cc356df0/attachment-0002.txt>
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: ip_type_ipv4.txt
URL: <https://lists.freedesktop.org/archives/modemmanager-devel/attachments/20191115/cc356df0/attachment-0003.txt>