[pulseaudio-discuss] Compiling pulseaudio for ThinStation 2.2.3

[Colin Guthrie]

'Twas brillig, and Stefan Adams at 13/11/08 09:11 did gyre and gimble:
> I'm trying to compile a package of pulseaudio for thinstation.  I've
> done that and it's apparently successful because there were no errors
> during compile.
> 
> I boot up thinstation and try to run pulseaudio and I get this
> horribly worthless message: "Floating point exception"
> That's it!  All by itself!  How can I proceed to solve the problem?
> Is it in pulseaudio?  Is it in one of the other libraries that I had
> to compile?  All compiling was done within the RUNME chroot
> environment provided by thinstation_src.
> 
> Any suggestions for how to "port?" pulseaudio to ThinStation?
> ThinStation right now is esd at best; it'd be great to roll out
> pulseaudio support.

+1 Not reaully sure what ThinStation is, but yay for PA support 
everywhere ;)

> # /bin/pulseaudio
> Floating point exception

Hmmm, not very useful :s

Can you try chaning the default resampler in daemon.conf?

By default it is speex-float-3, but you can try something simpler like 
"trivial".

There are also speex-fixed-0/1/2/3 too.

Might be where the FPE comes from... tho' I'm just guessing.

Col

-- 

Colin Guthrie
gmane(at)colin.guthr.ie
http://colin.guthr.ie/

Day Job:
   Tribalogic Limited [http://www.tribalogic.net/]
Open Source:
   Mandriva Linux Contributor [http://www.mandriva.com/]
   PulseAudio Hacker [http://www.pulseaudio.org/]
   Trac Hacker [http://trac.edgewall.org/]