[pulseaudio-discuss] Manually adding a delay to a PulseAudio sink

[Tanu Kaskinen]

On Wed, 2013-05-08 at 00:55 +0000, Mike Russo wrote:
> Tanu Kaskinen <tanuk <at> iki.fi> writes:
> 
> > 
> > On Tue, 2012-02-14 at 15:23 +0100, Frederik Vogelsang wrote:
> > There's no good way to do that yet, but it's being worked on. If all
> > goes well, you'll have a nice GUI for configuring that by the end of the
> > summer (and a way to do it on the command line before that).
> > 
> 
> 
> Any update on this? I recently got a little bluetooth transmitter
>  for a wireless speaker, and I'd loveto output to my regular speakers
>  and also the bluetooth transmitter, but I need to manually add a
>  little delay to the regular speakers so that the audio output will 
> match up with the delay caused by the bluetooth.  I've
>  tried using the loopback module but I'm not having any luck...

Pavucontrol 2.0 is able to configure the latency offset for each output
device (see the "Advanced" section below each device). Pulseaudio 3.0 is
required too.

-- 
Tanu

---------------------------------------------------------------------
Intel Finland Oy
Registered Address: PL 281, 00181 Helsinki 
Business Identity Code: 0357606 - 4 
Domiciled in Helsinki 

This e-mail and any attachments may contain confidential material for
the sole use of the intended recipient(s). Any review or distribution
by others is strictly prohibited. If you are not the intended
recipient, please contact the sender and delete all copies.