[pulseaudio-discuss] Stream corruption using simple API after network lag

Eric Thornton gonesurfingnc at yahoo.com
Sun Jan 25 17:57:38 PST 2015


Switched to using tunnel mode on the local machine and I am unable to reproduce the problem. This is definitely a pulseaudio bug using a direction connection with simple API over a network.
I will file a bug report. 

     On Wednesday, January 14, 2015 11:32 PM, Eric Thornton <gonesurfingnc at yahoo.com> wrote:
   

 Peter,
Thanks for your reply... thought I was having email trouble.
Here's what I've done to narrow it down to pulseaudio: 
-Using arecord, record a 96khz wav file of IQ audio several minutes long on the remote system.-Create two null sinks, both 96khz sample rate on the remote system.-Using paplay, I play back the recorded stream (which I've verified to be error free) to one null sink and connect the SDR application to null.monitor over wifi.-Connect the SDR application playback stream to the other null sink (to simulate the same network load)-Walk out to my garage for poor wifi signal while running the SDR application... after a few seconds of stuttering I get nothing but full volume white noise.
Unsure of what other tests to run at this point.
Thanks,
Eric Thornton



 

     On Tuesday, January 13, 2015 11:54 AM, Peter Meerwald <pmeerw at pmeerw.net> wrote:
   

 
> Resending. 

your message has been received, it's on the list, see 
http://lists.freedesktop.org/archives/pulseaudio-discuss/2015-January/022955.html

if the issue is not the underlying sound hardware, then probably it can be 
reproduced with a file source and hence much easier tested/debugged?

p.

-- 

Peter Meerwald
+43-664-2444418 (mobile)


    

   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20150126/554e0ee7/attachment.html>


More information about the pulseaudio-discuss mailing list