[pulseaudio-discuss] module-sine for generating two independent sine wave signals on the left and right output of a sound device

[Georg Chini]

On 11.11.2017 09:50, S.C.T.N Gmbh wrote:
>
> I want to use MODULE-SINE to produce two independent sine wave signals 
> with different frequencies on the left and right output of a sound card:
>
> By using :
>
> pactl load-module module-sine frequency=1000
>
> I get of course the same 1000Hz signal on both channels and
>
> pactl unload-module module-sine stops both of them.
>
> So the question is whether there is a configuration to start and stop 
> left and right channel independently and to run them with different 
> frequencies?
>
> Thank you in advance
>
> Sporex
>
You can use module-remap-sink to create independent sinks for each channel.
Then you can use module-sine on the remapped sinks.

Regards
              Georg
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20171111/db53e92e/attachment.html>