[pulseaudio-discuss] WG: AW: module-sine for generating two independent sine wave signals on the left and right output of a sound device

[S.C.T.N Gmbh]

pulseaudio 5.0

 

Linux TEST 4.9.35-v7+ #1014 SMP Fri Jun 30 14:47:43 BST 2017 armv7l
GNU/Linux  (Raspbian Jessie, Raspberry Pi 3)

The only thing I changed in the config files is:
exit-idle-time = -1 

In daemon.conf

 

Von: Georg Chini [mailto:georg at chini.tk] 
Gesendet: Samstag, 11. November 2017 20:58
An: General PulseAudio Discussion; S.C.T.N Gmbh
Betreff: Re: [pulseaudio-discuss] WG: AW: module-sine for generating two
independent sine wave signals on the left and right output of a sound device

 

On 11.11.2017 15:27, Georg Chini wrote:

On 11.11.2017 14:58, S.C.T.N Gmbh wrote:

please don't top post on that list.

Yes I can confirm that:

Pactl unload-module <index> 
stops the sine output on both channels. 

 

But in

pactl list modules short

the module<index> has disappeared while the other module-sine is still
there.


This definitely should not happen. I'll investigate and see if I can
reproduce the issue.




 

I cannot reproduce it here. For me it works and I can also immediately
reload module-sine after unloading. What platform are you on and
which version of PA are you using?

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20171112/b96d46bd/attachment.html>