[pulseaudio-discuss] WG: AW: module-sine for generating two independent sine wave signals on the left and right output of a sound device
georg at chini.tk
Sun Nov 12 11:23:25 UTC 2017
On 12.11.2017 09:13, S.C.T.N Gmbh wrote:
Please don't top post.
> pulseaudio 5.0
> Linux TEST 4.9.35-v7+ #1014 SMP Fri Jun 30 14:47:43 BST 2017 armv7l
> GNU/Linux (Raspbian Jessie, Raspberry Pi 3)
> The only thing I changed in the config files is:
> exit-idle-time = -1
> In daemon.conf
That is a very old version of pulse. Can you try current 11.1 or git?
> *Von:*Georg Chini [mailto:georg at chini.tk]
> *Gesendet:* Samstag, 11. November 2017 20:58
> *An:* General PulseAudio Discussion; S.C.T.N Gmbh
> *Betreff:* Re: [pulseaudio-discuss] WG: AW: module-sine for generating
> two independent sine wave signals on the left and right output of a
> sound device
> On 11.11.2017 15:27, Georg Chini wrote:
> On 11.11.2017 14:58, S.C.T.N Gmbh wrote:
> please don't top post on that list.
> Yes I can confirm that:
> Pactl unload-module <index>
> stops the sine output on both channels.
> But in
> pactl list modules short
> the module<index> has disappeared while the other module-sine
> is still there.
> This definitely should not happen. I'll investigate and see if I can
> reproduce the issue.
> I cannot reproduce it here. For me it works and I can also immediately
> reload module-sine after unloading. What platform are you on and
> which version of PA are you using?
> pulseaudio-discuss mailing list
> pulseaudio-discuss at lists.freedesktop.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the pulseaudio-discuss