[SCIM] Re: [Uim] scim-hangul 0.0.1 is available.

[Kitae]

Hi 

I checked with my two gentoo box, pentium4 and G3 ibook.
scim-hangul work fine with in OpenOffice and other gtk program.
pentium4 scim-version is 0.99.4 0.99.5 both work. 
Thanks a lot.
 
I was post yesterday but.. may something wrong. my posting disapper in
mailing list. so re post it. 
I hope it's not a spam.

Kitae
On Tue, 2004-08-03 at 01:14, David Oftedal wrote:
> James Su wrote:
> > Hi,
> >  scim-hangul is a Hangul IMEngine for SCIM, which is ported from 
> > imhangul.kldp.net project. An early snapshot is now available for 
> > testing. You may get it from 
> > http://scim.freedesktop.org/Software/ScimHangul
> >  The usage is almost same as imhangul. Just install scim 0.99.0 (or 
> > above) and scim-hangul, then you can type Hangul as well as Hanja with 
> > SCIM.
> >  A GUI Setup module will be available as soon as possible.
> > 
> >  Please help test it and give me feedback.
> > 
> > Regards
> > James Su
> 
> However, I was under the impression that UIM's uim-hangul2 and 
> uim-hangul3 were improvements upon imhangul? I remember being introduced 
> to UIM after asking a question about imhangul, but I'm not entirely sure 
> it was *this* imhangul, of course. At any rate, perhaps we'd better ask 
> the UIM team about it.
> 
> Oh wait, I'll just forward this to them as well. Hello, UIM! How's the 
> weather over there? :)
> 
> -David Oftedal
> _______________________________________________
> scim mailing list
> scim at freedesktop.org
> http://freedesktop.org/mailman/listinfo/scim
-- 
The thure is out there
___
Kitae