[PATCH] xdg-shell: Remove "edges" from description

[Bill Spitzak]

I would think configure request is going to need to provide this 
information. Otherwise the compositor cannot do tabbed or tiled layouts 
were it wants a window to resize without the client requesting it.

Then again perhaps it is ok for compositor-initiated resizing to always 
produce the same anchoring effect (ie whatever the client decides to do) 
so maybe this is ok. But I'm still concerned that it may be hard for a 
client to tell when resizing it initiated stops and other resizes start, 
so that it can change how it is handling the edges. Is this already 
solved in some other way?

Jasper St. Pierre wrote:
> The parameter was dropped...
> ---
>  protocol/xdg-shell.xml | 6 ------
>  1 file changed, 6 deletions(-)
> 
> diff --git a/protocol/xdg-shell.xml b/protocol/xdg-shell.xml
> index f0d04aa..7e4193b 100644
> --- a/protocol/xdg-shell.xml
> +++ b/protocol/xdg-shell.xml
> @@ -243,12 +243,6 @@
>  	ignore it if it doesn't resize, pick a smaller size (to
>  	satisfy aspect ratio or resize in steps of NxM pixels).
>  
> -	The edges parameter provides a hint about how the surface
> -	was resized. The client may use this information to decide
> -	how to adjust its content to the new size (e.g. a scrolling
> -	area might adjust its content position to leave the viewable
> -	content unmoved). Valid edge values are from resize_edge enum.
> -
>  	The client is free to dismiss all but the last configure
>  	event it received.
>