[pulseaudio-discuss] Help in setting up PA

[Richard Geddes]

Hi,

Just installed the PA packages on Ubuntu 7.10, with alsa drivers. 
Followed (I think) the steps for set up from the PA "Perfect setup" web
page... when I try to run audio through PA (aplay -Dpulse music.mp3) no
sound  goes to the speakers,  however,  I can see quite a few udp
packets being pushed through eth0... How can I get PA to send those
audio packets back to my audio card?

$0> sudo tshark
...
1200815959.616270 192.168.0.150 -> 224.0.0.56   RTP PT=16-bit
uncompressed audio, stereo, SSRC=0x97735F9C, Seq=56261, Time=4193600
...

$0> sudo netstat -entup
Active Internet connections (w/o servers)
Proto Recv-Q Send-Q Local Address           Foreign Address        
State       User       Inode      PID/Program name  
udp        0      0 192.168.0.150:32776     224.0.0.56:46900       
ESTABLISHED1000       38910      8009/pulseaudio    
udp        0      0 192.168.0.150:32777     224.0.0.56:9875        
ESTABLISHED1000       38911      8009/pulseaudio    

Some info about my audio hardware:

$0> sudo lspci -v
00:0e.0 Multimedia audio controller: VIA Technologies Inc. ICE1712
[Envy24] PCI Multi-Channel I/O Controller (rev 02)
        Subsystem: VIA Technologies Inc. M-Audio Delta 66
        Flags: bus master, medium devsel, latency 64, IRQ 10
        I/O ports at 10a0 [size=32]
        I/O ports at 1080 [size=16]
        I/O ports at 1010 [size=16]
        I/O ports at 1040 [size=64]
        Capabilities: [80] Power Management version 1

Thanks
Richard